Beko Dryer Error Code E16
The mains voltage reaching the dryer dropped below the safe minimum, so the dryer stopped to protect the compressor and motor. This is a supply problem, not a fault in the dryer.
Applies to: Beko heat-pump tumble dryers, BX B7S and BLED platform models
Common causes
- Low mains voltage in the home or the area
- Overloaded circuit shared with other large appliances
- Faulty socket or an unsuitable extension lead
What to check, in order
- Try a different socket, ideally on a different circuit.
- Avoid running other heavy appliances on the same circuit at the same time.
- Do not run a heat-pump dryer from an extension lead.
- If low voltage affects the whole home, contact your electricity supplier; repeated E16 on a healthy supply points to the dryer's voltage sensing — a technician job.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back.
- Close the door and plug the dryer back in (or restore its breaker).
- Run a short timed drying cycle with a small load and watch the point where the code appeared before.
- If the cycle finishes with no code, the fault is cleared. If the code returns, write down the code and the stage before calling a technician — it speeds up the diagnosis.
When to call a professional
This display is not a fault, so there is normally nothing to book. Call a technician only if the machine also behaves abnormally, or if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E16, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Parts that may be involved
Control board
Parts are model-specific. Find your model number first — usually on a label inside the door or on the back — and match the part to that number before ordering.
Questions people ask about E16
What does E16 mean on a Beko dryer?
E16 means: Supply voltage too low (below 165 V). The mains voltage reaching the dryer dropped below the safe minimum, so the dryer stopped to protect the compressor and motor. This is a supply problem, not a fault in the dryer.
Can I fix Beko E16 myself?
There is nothing to fix: code E16 is a status display, not a fault. The checks on this page show how to exit the mode or confirm the setting.
How do I clear Beko E16?
Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back. Close the door and plug the dryer back in (or restore its breaker). Run a short timed drying cycle with a small load and watch the point where the code appeared before.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.