Beko Dryer Error Code E02
The condensate water tank is full, or the dryer thinks it is. On models plumbed into a drain, a blocked drain hose or a faulty level sensor gives the same code.
Also shown as: E2
Applies to: Beko heat-pump tumble dryers, BX B7S and BLED platform models
Common causes
- Condensate tank full
- Tank not seated correctly
- Blocked condensate drain hose (on plumbed-in models)
- Faulty tank level sensor or float
What to check, in order
- Pull out the water tank, empty it, and push it fully back in.
- If the dryer drains through a hose, check the hose is not kinked or blocked.
- Wipe the level sensor contacts in the tank housing clean.
- If the code shows with an empty tank, the level sensor or float needs checking — a technician job.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back.
- Close the door and plug the dryer back in (or restore its breaker).
- Run a short timed drying cycle with a small load and watch the point where the code appeared before.
- If the cycle finishes with no code, the fault is cleared. If the code returns, write down the code and the stage before calling a technician — it speeds up the diagnosis.
When to call a professional
Most cases are solved by the checks above. Book a technician if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E02, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Parts that may be involved
Water tankLevel sensor
Parts are model-specific. Find your model number first — usually on a label inside the door or on the back — and match the part to that number before ordering.
Questions people ask about E02
What does E02 mean on a Beko dryer?
E02 means: Water tank full. The condensate water tank is full, or the dryer thinks it is. On models plumbed into a drain, a blocked drain hose or a faulty level sensor gives the same code.
Can I fix Beko E02 myself?
Usually, yes. Code E02 is rated DIY-friendly: the checks on this page cover the common causes and use basic household items only. If the code returns after the checks and a test cycle, book a technician.
How do I clear Beko E02?
Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back. Close the door and plug the dryer back in (or restore its breaker). Run a short timed drying cycle with a small load and watch the point where the code appeared before.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.