Beko Dryer Error Code E06
The temperature sensor by the door is reading open circuit, so the dryer cannot monitor the air temperature and stops. The sensor itself or its wiring has failed.
Also shown as: E6
Applies to: Beko heat-pump tumble dryers, BX B7S and BLED platform models
Common causes
- Failed door NTC sensor
- Broken wire or loose connector to the sensor
- Control board fault
What to check, in order
- Switch the dryer off at the socket for a few minutes and retry — a one-off bad reading can clear.
- Clean the lint filter and the heat-exchanger filter, and do not keep forcing restarts, as temperature control is unreliable with this fault.
- Testing the sensor (about 12 kΩ at 25°C) and replacing it is a technician job.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back.
- Close the door and plug the dryer back in (or restore its breaker).
- Run a short timed drying cycle with a small load and watch the point where the code appeared before.
- If the cycle finishes with no code, the fault is cleared. If the code returns, write down the code and the stage before calling a technician — it speeds up the diagnosis.
When to call a professional
This code usually points to a faulty part, wiring or the control board on a Beko dryer. Run the checks above to rule out the simple causes, then book a technician — and book one straight away if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E06, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Repair or replace?
This fault is in professional territory: the fix usually means a major part or board-level work, and the labour adds up. If your machine is already well into its service life, get the repair quote first, then compare it with the price of a current equivalent model before you decide. Paying a large share of a new machine's price to repair an old one is rarely the better deal; replacing a machine over one cheap fault is wasteful too.
Parts that may be involved
Door NTC sensorControl board
Parts are model-specific. Find your model number first — usually on a label inside the door or on the back — and match the part to that number before ordering.
Questions people ask about E06
What does E06 mean on a Beko dryer?
E06 means: Door temperature sensor (NTC) open circuit. The temperature sensor by the door is reading open circuit, so the dryer cannot monitor the air temperature and stops. The sensor itself or its wiring has failed.
Can I fix Beko E06 myself?
Only the preliminary checks. Code E06 usually means a part, wiring or the control board has failed, which is a technician job. Run the checks to rule out simple causes before you book.
How do I clear Beko E06?
Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back. Close the door and plug the dryer back in (or restore its breaker). Run a short timed drying cycle with a small load and watch the point where the code appeared before.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.