Beko Dryer Error Code E13
Airflow through the filters has fallen too low. This is the dryer's own maintenance warning: clean the lint filter and the filter in front of the heat exchanger.
Applies to: Beko heat-pump tumble dryers, BX B7S and BLED platform models
Common causes
- Lint filter clogged
- Foam filter or heat-exchanger filter clogged
- Lint build-up inside the filter housing
What to check, in order
- Rinse the lint filter if the manual allows it, and let it dry fully.
- Remove and wash the sponge or condenser filter in the lower compartment.
- Vacuum lint from the filter housing and brush the heat-exchanger fins gently.
- Restart the programme; the code clears once airflow is restored.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back.
- Close the door and plug the dryer back in (or restore its breaker).
- Run a short timed drying cycle with a small load and watch the point where the code appeared before.
- If the cycle finishes with no code, the fault is cleared. If the code returns, write down the code and the stage before calling a technician — it speeds up the diagnosis.
When to call a professional
Most cases are solved by the checks above. Book a technician if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E13, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Parts that may be involved
Lint filterCondenser filter
Parts are model-specific. Find your model number first — usually on a label inside the door or on the back — and match the part to that number before ordering.
Questions people ask about E13
What does E13 mean on a Beko dryer?
E13 means: Filter blocked. Airflow through the filters has fallen too low. This is the dryer's own maintenance warning: clean the lint filter and the filter in front of the heat exchanger.
Can I fix Beko E13 myself?
Usually, yes. Code E13 is rated DIY-friendly: the checks on this page cover the common causes and use basic household items only. If the code returns after the checks and a test cycle, book a technician.
How do I clear Beko E13?
Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back. Close the door and plug the dryer back in (or restore its breaker). Run a short timed drying cycle with a small load and watch the point where the code appeared before.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.