Beko Dryer Error Code E11
The compressor circuit is running hotter than it should. Blocked filters make the heat pump work harder and are the first thing to fix; a failing sensor gives the same warning.
Applies to: Beko heat-pump tumble dryers, BX B7S and BLED platform models
Common causes
- Clogged lint filter or heat-exchanger filter
- Poor ventilation or a hot room
- Failed compressor NTC sensor drifting high
- Heat-pump fault making the compressor overheat
What to check, in order
- Stop the cycle and let the dryer cool down completely.
- Clean the lint filter and wash the heat-exchanger filter.
- Make sure air can circulate around the dryer and the room is not excessively hot.
- If E11 returns on a small load with clean filters, the sensor and the heat pump need testing — a technician job.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back.
- Close the door and plug the dryer back in (or restore its breaker).
- Run a short timed drying cycle with a small load and watch the point where the code appeared before.
- If the cycle finishes with no code, the fault is cleared. If the code returns, write down the code and the stage before calling a technician — it speeds up the diagnosis.
When to call a professional
Most cases are solved by the checks above. Book a technician if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E11, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Parts that may be involved
Compressor NTC sensorLint filterHeat exchanger filter
Parts are model-specific. Find your model number first — usually on a label inside the door or on the back — and match the part to that number before ordering.
Questions people ask about E11
What does E11 mean on a Beko dryer?
E11 means: Compressor temperature sensor (NTC) overheating. The compressor circuit is running hotter than it should. Blocked filters make the heat pump work harder and are the first thing to fix; a failing sensor gives the same warning.
Can I fix Beko E11 myself?
Start yourself: the checks on this page cover the causes you can reach without opening the machine up. If they point to a faulty part, testing or replacing it is usually a technician job.
How do I clear Beko E11?
Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back. Close the door and plug the dryer back in (or restore its breaker). Run a short timed drying cycle with a small load and watch the point where the code appeared before.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.