Beko Dryer Error Code E01
The dryer detected the door opening, or losing its closed signal, while a programme was running, so it stopped. Usually the door was not fully latched or the load pushed against it.
Also shown as: E1
Applies to: Beko heat-pump tumble dryers, BX B7S and BLED platform models
Common causes
- Door not fully closed or latched
- Faulty door switch or lock
- Bulky load pushing the door open
- Wiring fault to the door switch
What to check, in order
- Close the door firmly and restart the programme.
- Check the door catch and the striker for damage or lint build-up.
- Clean lint from around the door seal and the switch area.
- If the code returns with the door shut, the door switch needs testing — a technician job.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back.
- Close the door and plug the dryer back in (or restore its breaker).
- Run a short timed drying cycle with a small load and watch the point where the code appeared before.
- If the cycle finishes with no code, the fault is cleared. If the code returns, write down the code and the stage before calling a technician — it speeds up the diagnosis.
When to call a professional
Most cases are solved by the checks above. Book a technician if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E01, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Parts that may be involved
Door switchDoor catch
Parts are model-specific. Find your model number first — usually on a label inside the door or on the back — and match the part to that number before ordering.
Questions people ask about E01
What does E01 mean on a Beko dryer?
E01 means: Door opened while running. The dryer detected the door opening, or losing its closed signal, while a programme was running, so it stopped. Usually the door was not fully latched or the load pushed against it.
Can I fix Beko E01 myself?
Usually, yes. Code E01 is rated DIY-friendly: the checks on this page cover the common causes and use basic household items only. If the code returns after the checks and a test cycle, book a technician.
How do I clear Beko E01?
Fix what the checks above found first — a filter cleaned, the vent or hose freed. Clearing the code without fixing the cause only brings it back. Close the door and plug the dryer back in (or restore its breaker). Run a short timed drying cycle with a small load and watch the point where the code appeared before.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.