Bosch Oven Error Code F113
F113 is the more severe of the two runaway-temperature codes for the upper or single oven: the cavity passed an even higher safety threshold than F111. Treat it the same way — power off at the breaker, let it cool, and have the relay board and sensor tested before the oven is used again.
Common causes
- Heating relay contacts welded closed on the power board
- Temperature sensor grossly misreading
- Control board failure
What to check, in order
- Turn the power off at the breaker immediately and leave it off until the oven is cold; cancelling the cycle will not stop a stuck relay.
- Allow several hours for a very hot cavity to cool before opening the door.
- Record which mode was running and roughly how hot the oven got, for the technician.
- Book a technician: the fix is a power board and/or sensor replacement, and the oven should not be used until it is done.
Clear the code and test
- Fix what the checks above found first. Clearing the code without fixing the cause only brings it back.
- Plug the appliance back in and restore its water supply if it has one.
- Run the shortest programme and watch the point where the code appeared before.
- If the programme finishes with no code, the fault is cleared. If the code returns, write it down before calling a technician — it speeds up the diagnosis.
When to call a professional
This code usually points to a faulty part, wiring or the control board on a Bosch oven. Run the checks above to rule out the simple causes, then book a technician — and book one straight away if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it at the tap.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code F113, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Repair or replace?
This fault is in professional territory: the fix usually means a major part or board-level work, and the labour adds up. If your machine is already well into its service life, get the repair quote first, then compare it with the price of a current equivalent model before you decide. Paying a large share of a new machine's price to repair an old one is rarely the better deal; replacing a machine over one cheap fault is wasteful too.
Parts that may be involved
Power board (relay board)Oven temperature sensor
Parts are model-specific. Find your model number first — usually on a label inside the door, on the door frame or on the back — and match the part to that number before ordering.
Questions people ask about F113
What does F113 mean on a Bosch oven?
F113 means: Runaway oven temperature at the higher limit (upper or single oven). F113 is the more severe of the two runaway-temperature codes for the upper or single oven: the cavity passed an even higher safety threshold than F111. Treat it the same way — power off at the breaker, let it cool, and have the relay board and sensor tested before the oven is used again.
Can I fix Bosch F113 myself?
Only the preliminary checks. Code F113 usually means a part, wiring or the control board has failed, which is a technician job. Run the checks to rule out simple causes before you book.
How do I clear Bosch F113?
Fix the cause first — clearing the code on its own brings it straight back. Then restore power and water, run the shortest programme, and watch the stage where the code appeared. If the programme finishes with no code, it is cleared.
Sources checked
- Bosch Home (US) owner support: dishwasher error codes
- Coolblue advice: Bosch and Siemens washing machine errors
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.