Bosch Dishwasher Error Code E14
The flow meter is the small sensor that counts how much water flows in during filling, and the machine cannot confirm the fill is correct. Sometimes the real problem is at the tap or in the inlet hose rather than the sensor itself. Work through the supply checks first; if water clearly flows in but the code stays, the meter needs replacing.
Also shown as: E3000
Common causes
- Failed flow meter (reed switch) in the filling system
- Tap not fully open or low water pressure
- Kinked or blocked inlet hose
- Clogged inlet filter screen
What to check, in order
- Make sure the supply tap is fully open.
- Check the inlet hose for kinks and straighten it.
- Turn off the tap, unscrew the inlet hose and rinse the small filter screen where it connects.
- Run a cycle; if the machine fills but E14 returns, book a technician for the flow meter.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, a hose straightened, the spray arms freed. Clearing the code without fixing the cause only brings it back.
- Close the door, plug the dishwasher back in (or restore its breaker) and make sure the water tap is open.
- Run the shortest programme and stay nearby for the first minutes, watching for leaks and listening for the drain pump.
- If the programme finishes with no code, the fault is cleared. If the code returns, write down the code and when it appeared before calling a technician — it speeds up the diagnosis.
When to call a professional
Most cases are solved by the checks above. Book a technician if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it at the tap.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E14, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Parts that may be involved
Flow meterWater inlet valveInlet hose and filter screen
Parts are model-specific. Find your model number first — usually on a label inside the door, on the door frame or on the back — and match the part to that number before ordering.
Questions people ask about E14
What does E14 mean on a Bosch dishwasher?
E14 means: Flow meter fault or problem with water entering the machine. The flow meter is the small sensor that counts how much water flows in during filling, and the machine cannot confirm the fill is correct. Sometimes the real problem is at the tap or in the inlet hose rather than the sensor itself. Work through the supply checks first; if water clearly flows in but the code stays, the meter needs replacing.
Can I fix Bosch E14 myself?
Start yourself: the checks on this page cover the causes you can reach without opening the machine up. If they point to a faulty part, testing or replacing it is usually a technician job.
How do I clear Bosch E14?
Fix the cause first — clearing the code on its own brings it straight back. Then restore power and water, run the shortest programme, and watch the stage where the code appeared. If the programme finishes with no code, it is cleared.
Sources checked
- Bosch Home (US) owner support: dishwasher error codes
- Coolblue advice: Bosch and Siemens washing machine errors
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.