Bosch Dishwasher Error Code E06
The machine cannot reliably tell whether the door is closed and locked, so it will not start or it pauses mid-cycle. Sometimes the cause is as simple as the door not latching fully or something pushing against it. If the door closes firmly and the code stays, the door sensor or its wiring has failed.
Also shown as: E8000, E6
Common causes
- Door not latching fully
- Worn or broken door latch
- Failed door sensor (reed/Hall sensor)
- Damaged wiring in the door
What to check, in order
- Open and close the door firmly and check nothing inside is pushing it ajar.
- Inspect the latch area for broken plastic or trapped debris.
- Reset power at the breaker for 30 seconds and try again.
- If the code persists with the door shut tight, book a technician to test the door sensor.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, a hose straightened, the spray arms freed. Clearing the code without fixing the cause only brings it back.
- Close the door, plug the dishwasher back in (or restore its breaker) and make sure the water tap is open.
- Run the shortest programme and stay nearby for the first minutes, watching for leaks and listening for the drain pump.
- If the programme finishes with no code, the fault is cleared. If the code returns, write down the code and when it appeared before calling a technician — it speeds up the diagnosis.
When to call a professional
Most cases are solved by the checks above. Book a technician if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it at the tap.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E06, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Parts that may be involved
Door latchDoor sensorDoor wiring harness
Parts are model-specific. Find your model number first — usually on a label inside the door, on the door frame or on the back — and match the part to that number before ordering.
Questions people ask about E06
What does E06 mean on a Bosch dishwasher?
E06 means: Door sensor circuit fault. The machine cannot reliably tell whether the door is closed and locked, so it will not start or it pauses mid-cycle. Sometimes the cause is as simple as the door not latching fully or something pushing against it. If the door closes firmly and the code stays, the door sensor or its wiring has failed.
Can I fix Bosch E06 myself?
Start yourself: the checks on this page cover the causes you can reach without opening the machine up. If they point to a faulty part, testing or replacing it is usually a technician job.
How do I clear Bosch E06?
Fix the cause first — clearing the code on its own brings it straight back. Then restore power and water, run the shortest programme, and watch the stage where the code appeared. If the programme finishes with no code, it is cleared.
Sources checked
- Bosch Home (US) owner support: dishwasher error codes
- Coolblue advice: Bosch and Siemens washing machine errors
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.