Beko Refrigerator Error Code E8
The ice maker temperature sensor is reading open or short circuit. The ice maker stops working, but the fridge and freezer sections keep cooling normally.
Also shown as: E08
Applies to: Beko American-style side-by-side and multi-door fridge freezers with a display, ASD (Cosmos) series and similar models
Common causes
- Failed ice maker sensor
- Damaged sensor wiring
- Faulty control module
What to check, in order
- Switch the ice maker off and on again in the controls, and reset the appliance at the socket for 10 minutes.
- Check the ice maker area for ice jams around the sensor.
- If E8 returns, the sensor needs testing — a technician job.
Clear the code and test
- Fix what the checks above found first — a vent cleared, the doors sealing again, the coils cleaned. Clearing the code without fixing the cause only brings it back.
- Plug the fridge back in and make sure both doors close fully.
- Leave the doors closed and give the fridge time: check after about an hour whether the code has gone and the temperature is dropping again.
- If the code is still showing after a few hours, or the temperature is not recovering, write the code down before calling a technician — it speeds up the diagnosis.
When to call a professional
This code usually points to a faulty part, wiring or the control board on a Beko refrigerator. Run the checks above to rule out the simple causes, then book a technician — and book one straight away if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E8, your model number (on a label inside, on the side wall) and the checks you already ran. It shortens the visit.
Repair or replace?
This fault is in professional territory: the fix usually means a major part or board-level work, and the labour adds up. If your machine is already well into its service life, get the repair quote first, then compare it with the price of a current equivalent model before you decide. Paying a large share of a new machine's price to repair an old one is rarely the better deal; replacing a machine over one cheap fault is wasteful too.
Parts that may be involved
Ice maker sensorIce maker unit
Parts are model-specific. Find your model number first — usually on a label inside, on the side wall — and match the part to that number before ordering.
Questions people ask about E8
What does E8 mean on a Beko refrigerator?
E8 means: Ice maker sensor error. The ice maker temperature sensor is reading open or short circuit. The ice maker stops working, but the fridge and freezer sections keep cooling normally.
Can I fix Beko E8 myself?
Only the preliminary checks. Code E8 usually means a part, wiring or the control board has failed, which is a technician job. Run the checks to rule out simple causes before you book.
How do I clear Beko E8?
Fix what the checks above found first — a vent cleared, the doors sealing again, the coils cleaned. Clearing the code without fixing the cause only brings it back. Plug the fridge back in and make sure both doors close fully. Leave the doors closed and give the fridge time: check after about an hour whether the code has gone and the temperature is dropping again.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.