Home › Bosch error codes › Error code E32

Bosch Washing Machine Error Code E32

Not a faultReviewed November 2026Checked against manufacturer documentation

What this code means

E32: Unbalanced load (alternates with End)

E32 is not a fault. The machine interrupted the cycle because the laundry is distributed unevenly, and it may alternate E32 with End on the display.

Also shown as: F32

Fix level

Not a fault

This is a status display, not a fault. No repair is needed.

Time to run the checks

About 15–30 minutes

For the 3 checks on this page — not a full repair.

You may need

Towel

Named in the checks below.

Parts that may be involved

None usually

Parts are model-specific; see the note below before ordering.

Common causes

Single heavy item such as a bath mat or duvet
Laundry balled up on one side
Load too small to distribute

What to check, in order

Safety first. Switch the machine off and unplug it before cleaning filters or moving hoses. Expect water to come out when you open a pump filter; keep a tray and towel ready. If you are not comfortable with any step, stop and call a technician.

Redistribute the laundry evenly, mixing large and small items.
Add a towel or two when washing one heavy item alone.
Start a spin programme to finish the load.

Clear the code and test

Fix what the checks above found first — a filter cleaned, a hose straightened, taps opened. Clearing the code without fixing the cause only brings it back.
Close the door, plug the machine back in and restore the water supply.
Run a short rinse and spin, or the shortest wash programme, and watch the stage where the code appeared before (filling, washing, draining or spinning).
If the cycle finishes with no code, the fault is cleared. If the code returns at the same stage, write down the code and that stage before calling a technician — it speeds up the diagnosis.

When to call a professional

This display is not a fault, so there is normally nothing to book. Call a technician only if the machine also behaves abnormally, or if any of these apply:

The code comes back after you have run the checks and a test cycle.
You smell burning, see sparks or scorch marks, or the breaker trips.
Water is leaking and you cannot stop it at the tap.
The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.

When you call, give the brand, the code E32, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.

Questions people ask about E32

What does E32 mean on a Bosch washing machine?

E32 means: Unbalanced load (alternates with End). E32 is not a fault. The machine interrupted the cycle because the laundry is distributed unevenly, and it may alternate E32 with End on the display.

Can I fix Bosch E32 myself?

There is nothing to fix: code E32 is a status display, not a fault. The checks on this page show how to exit the mode or confirm the setting.

How do I clear Bosch E32?

Fix the cause first — clearing the code on its own brings it straight back. Then restore power and water, run the shortest programme, and watch the stage where the code appeared. If the programme finishes with no code, it is cleared.

Sources checked

The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.