Bosch Dryer Error Code E06
E06 points to a fault in the heating circuit, so the dryer stops rather than run without safe temperature control. One power reset is worth trying, but Bosch is clear that the repair itself is a job for a technician.
Common causes
- Failed heating element (vented and condenser models)
- Heat pump fault (heat pump models)
- Faulty temperature sensor (NTC) in the heating circuit
- Heater relay or wiring fault on the control board
What to check, in order
- Switch the dryer off, unplug it for a few minutes, then restore power and start a short timed programme.
- Note whether the drum turns and whether there is any warmth at all inside, and pass this on to the technician.
- Clean the fluff filter and heat exchanger area; this rules out an airflow problem but will not repair a heating fault.
- If E06 returns, stop using the dryer and book a service visit. Bosch states this fault can only be fixed by a technician.
Clear the code and test
- Fix what the checks above found first. Clearing the code without fixing the cause only brings it back.
- Plug the appliance back in and restore its water supply if it has one.
- Run the shortest programme and watch the point where the code appeared before.
- If the programme finishes with no code, the fault is cleared. If the code returns, write it down before calling a technician — it speeds up the diagnosis.
When to call a professional
This code usually points to a faulty part, wiring or the control board on a Bosch dryer. Run the checks above to rule out the simple causes, then book a technician — and book one straight away if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it at the tap.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E06, your model number (on a label inside the door or on the back) and the checks you already ran. It shortens the visit.
Repair or replace?
This fault is in professional territory: the fix usually means a major part or board-level work, and the labour adds up. If your machine is already well into its service life, get the repair quote first, then compare it with the price of a current equivalent model before you decide. Paying a large share of a new machine's price to repair an old one is rarely the better deal; replacing a machine over one cheap fault is wasteful too.
Parts that may be involved
Heating elementHeat pumpTemperature sensor (NTC)Main control board
Parts are model-specific. Find your model number first — usually on a label inside the door, on the door frame or on the back — and match the part to that number before ordering.
Questions people ask about E06
What does E06 mean on a Bosch dryer?
E06 means: Fault in the heating circuit: the dryer cannot produce heat safely. E06 points to a fault in the heating circuit, so the dryer stops rather than run without safe temperature control. One power reset is worth trying, but Bosch is clear that the repair itself is a job for a technician.
Can I fix Bosch E06 myself?
Only the preliminary checks. Code E06 usually means a part, wiring or the control board has failed, which is a technician job. Run the checks to rule out simple causes before you book.
How do I clear Bosch E06?
Fix the cause first — clearing the code on its own brings it straight back. Then restore power and water, run the shortest programme, and watch the stage where the code appeared. If the programme finishes with no code, it is cleared.
Sources checked
- Bosch Home (US) owner support: dishwasher error codes
- Coolblue advice: Bosch and Siemens washing machine errors
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.