Beko Dishwasher Error Code E06
The sensor that measures the wash water temperature is open or short circuit, so the machine cannot control the heating and stops the programme.
Also shown as: E6
Applies to: Beko dishwashers with a display, DFN and BDFN series models
Common causes
- Failed NTC temperature sensor
- Loose or corroded sensor connector
- Damaged wiring between the sensor and the control board
- Control board fault
What to check, in order
- Switch the machine off at the socket for a few minutes and retry a programme.
- Note whether the water heats at all on a hot programme — cold water together with E06 points at the sensor circuit.
- Sensor testing and replacement is internal work — a technician job.
Clear the code and test
- Fix what the checks above found first — a filter cleaned, a hose straightened, the spray arms freed. Clearing the code without fixing the cause only brings it back.
- Close the door, plug the dishwasher back in (or restore its breaker) and make sure the water tap is open.
- Run the shortest programme and stay nearby for the first minutes, watching for leaks and listening for the drain pump.
- If the programme finishes with no code, the fault is cleared. If the code returns, write down the code and when it appeared before calling a technician — it speeds up the diagnosis.
When to call a professional
This code usually points to a faulty part, wiring or the control board on a Beko dishwasher. Run the checks above to rule out the simple causes, then book a technician — and book one straight away if any of these apply:
- The code comes back after you have run the checks and a test cycle.
- You smell burning, see sparks or scorch marks, or the breaker trips.
- Water is leaking and you cannot stop it.
- The fix needs panels opened beyond what your manual describes, or a part tested with a meter, and you are not set up for that.
When you call, give the brand, the code E06, your model number (on a label on the edge of the door) and the checks you already ran. It shortens the visit.
Repair or replace?
This fault is in professional territory: the fix usually means a major part or board-level work, and the labour adds up. If your machine is already well into its service life, get the repair quote first, then compare it with the price of a current equivalent model before you decide. Paying a large share of a new machine's price to repair an old one is rarely the better deal; replacing a machine over one cheap fault is wasteful too.
Parts that may be involved
NTC temperature sensorControl board
Parts are model-specific. Find your model number first — usually on a label on the edge of the door — and match the part to that number before ordering.
Questions people ask about E06
What does E06 mean on a Beko dishwasher?
E06 means: Water temperature sensor (NTC) error. The sensor that measures the wash water temperature is open or short circuit, so the machine cannot control the heating and stops the programme.
Can I fix Beko E06 myself?
Only the preliminary checks. Code E06 usually means a part, wiring or the control board has failed, which is a technician job. Run the checks to rule out simple causes before you book.
How do I clear Beko E06?
Fix what the checks above found first — a filter cleaned, a hose straightened, the spray arms freed. Clearing the code without fixing the cause only brings it back. Close the door, plug the dishwasher back in (or restore its breaker) and make sure the water tap is open. Run the shortest programme and stay nearby for the first minutes, watching for leaks and listening for the drain pump.
Sources checked
The meaning and checks for this code were checked against the sources above in November 2026. Codes vary by model and region; if your manual lists a different meaning for your exact model, follow the manual.